Mean Well LPC-100-2100

LPC-100-2100
Импульсный блок питания 100 Вт со стабилизацией выхода по току. (LED драйвер). Iвых 2100 мА, Uвых от 24 до 48 VDC, Pвых 100.8 Вт, Uвх от 90 до 264 VAC / от 127 до 370 VDC. IP67. Технические характеристики MODEL LPC-100-2100 RATED CURRENT 2100mA CURRENT ACCURACY ±5.0% CO ...Читать далее

Цены

Договорная
Нет голосов


Купить

  • Описание
  • Характеристики
  • Опубликовать комментарий

Импульсный блок питания 100 Вт со стабилизацией выхода по току. (LED драйвер). Iвых 2100 мА, Uвых от 24 до 48 VDC, Pвых 100.8 Вт, Uвх от 90 до 264 VAC / от 127 до 370 VDC. IP67.

Технические характеристики

MODEL LPC-100-2100
RATED CURRENT 2100mA
CURRENT ACCURACY ±5.0%
CONSTANT CURRENT REGION Note.5 24 ~ 48V
RATED POWER 100.8W
RIPPLE CURRENT ±5%
RIPPLE & NOISE 1Vp-p
LINE REGULATION ±1%
VOLTAGE TOLERANCE ±1.5%
SETUP, RISE TIME 1000ms, 80ms / 230VAC 2000ms,80ms/115VAC at full load
HOLD UP TIME (Typ.) 16ms/230VAC    10ms/115vac at full load
VOLTAGE RANGE Note.2 90 ~ 264VAC    127VDC ~ 370VDC
FREQUENCY RANGE 47 ~ 63Hz
EFFICIENCY (Typ.) 89%
AC CURRENT (Typ.) 2.2 A / 115VAC    1.2A / 230VAC
INRUSH CURRENT (Typ.) COLD START 75A(twidth=980μs measured at 50% Ipeak) at 230VAC
MAX. No. of PSUs on 16A CIRCUIT BREAKER CIRCUIT BREAKER 1 units (circuit breaker of type B) / 2 units (circuit breaker of type C) at 230VAC
LEAKAGE CURRENT ​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​<0,25mA/240VAC
SHORT CIRCUIT Hiccup mode, recovers automatically after fault condition is removed
OVER VOLTAGE 58 ~ 68V
Protection type : Shut down and latch off o/p voltage re-power on to recovery
WORKING TEMP. -25 ~ +50℃ (Refer to "Derating Curve")
WORKING HUMIDITY 10 ~ 95% RH non-condensing
STORAGE TEMP., HUMIDITY -40 ~ +80℃, 10 ~ 95% RH
TEMP. COEFFICIENT ±0.03%/℃ (0 ~ 50℃)
VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY STANDARDS EAC TP TC 004, IP67 approved,Design refer to TUV EN60950-1
WITHSTAND VOLTAGE I/P-O/P:3KVAC
ISOLATION RESISTANCE I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
EMC EMISSION Compliance to EN55032(CISPR32) Class B; EN61000-3-2 Class A(≦80% load); EN61000-3-3, EAC TP TC 020м
EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level , criteria A, EAC TP TC 020
MTBF 511Khrs min.    MIL-HDBK-217F (25℃)
DIMENSION 190*52*37mm (L*W*H)
PACKING 0.61Kg;20pcs/13.2Kg/0.55CUFT


  1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 °С of ambient temperature.
  2. Derating may be needed under low input voltages. Please check the static characteristics for more details.
  3. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC perlormance will be affected by the complete installalion, the final equipment manulamurers must re-qualily EMC Directive on lhe complete installation again.
  4. Refer to warranty statement.
  5. Constant current operation region is within 50% ~100% rated oulput voltage. This is the suitable operation region for LED related applications, but please reconfirm special electrical requirements for some specific system design.
  6. Suitable for indoor use or outdoor use winhout direct sunlight exposure, please avoid immerse in the water over 30minutes.
  7. The ambient temperature derating ol 3.5°С/1000m with finless models and of 5°С/1000m with fan models for opelating altitude higher than 2000m(6500ft].
  8. For any application note and IP water proof function installation caution, please refer our user manual before using. hllps://www.meanwell.com/Upload/PDF/LED_EN.pdf
  9. This product is not intended for LED applications in the EU.(ln the EU NPF/LPF/XLG series are recommended.)
  10. To fulfill requirements of latest ErP regulation for lighting luminaires, this LED Driver can only be used behind a switch without permanently connected to mains.
Вы должны зарегистрироваться или войти под своим именем, чтобы оставить комментарий