The following table contains the sound velocity values of various gases measured at 20 °C.
- Информация о материале
- Родительская категория: EasyTREK SP-500
- Категория: En
Thank you for choosing a NIVELCO instrument. We are sure that you will be satisfied throughout its use.
- Информация о материале
- Автор: Батон
- Родительская категория: EasyTREK SP-500
- Категория: En
- Информация о материале
- Родительская категория: EasyTREK SP-500
- Категория: En
EasyTREK SP units do not require maintenance on a regular basis. The need for cleaning of the sensor head may occur. Cleaning should be performed by utmost care where scraping or denting of the transducer have to be avoided.
- Информация о материале
- Родительская категория: EasyTREK SP-500
- Категория: En
Measurement will be according to the factory setting. The factory setting is throughout apt to check proper working and to perform simple measurement tasks but features residing in the unit can only be utilised by adjusting the EasyTREK to the application by programming.
- Информация о материале
- Родительская категория: EasyTREK SP-500
- Категория: En
Should extension be needed the use of connection box is suggested. The shielding of the two cables should be connected and grounded at the signal processing device.
- Информация о материале
- Родительская категория: EasyTREK SP-500
- Категория: En
Foaming of the liquid surface may render ultrasonic level metering impossible. If possible, a location should be found, where foaming is the least (device should be located as far as possible from liquid inflow) or a stilling pipe or well should be used.
- Информация о материале
- Родительская категория: EasyTREK SP-500
- Категория: En
- Информация о материале
- Родительская категория: EasyTREK SP-500
- Категория: En
1. INTRODUCTION
2. TECHNICAL DATA
2.1. General data
2.2. Special data
2.3. Accessories
2.4. Order codes (Not all combinations are available)
2.5. Dimensions
3. INSTALLATION
3.1. Liquid Level Measurement
3.2. Open channel flow measurement
4. WIRING
5. PUTTING INTO OPERATION
5.1. Usage
5.2. Special conditions of safe use
5.3. Programming
5.3.1. Measurement configuration
5.3.2. Current Output
5.3.3. Relay Output
5.3.4. Digital communication
5.3.5. Measurement optimisation
5.3.6. Volume (content) measurement
5.3.7. Open channel flow measurement
5.3.8. Programming the VOLUME / MASS / FLOW TABLE)
5.3.9. Informational parameters (read only parameters)
5.3.10. Additional parameters of the flow metering
5.3.11. Other parameters
6. MAINTENANCE AND REPAIR
6.1. Firmware upgrade
7. ERROR CODES
8. PARAMETER TABLE
9. SOUND VELOCITY VALUES IN DIFFERENT GASES
- Информация о материале
- Автор: Батон
- Родительская категория: EasyTREK SP-500
- Категория: En